Makes it easy to beautify your property with sharp, clean edges around paths, flower beds and bushes. Wheel and hardened spring-steel blade attaches easily to your tiller.

Cuts neat, crisp edges where your flower beds meet the lawn. Maintains a sharp edge between lawn and gardens.

Forms straight, uniform furrows, both deep and shallow, much faster and more simply than you could do by hand. It's the ideal planting attachment for backyard vegetable gardeners! Propelled forward by the spinning tiller tines, the hardened steel plow blade quickly and easily creates planting furrows.

Creates uniform planting furrows in tilled soil, faster than by hand. Easy walk-forward motion. Banks soil for fatigue-free planting.

Wheel Set (shown with optional Crevice Cleaner attachment) attaches to your Mantis Tiller in minutes. Let's you have the option to roll or carry your Tiller to your garden. Park your Mantis Tiller in an upright position to add fuel, or store it upright when you don't have a wall to lean it against! Wheels add stability when you use the Crevice Cleaner or Border Edger attachments. Rubber wheels make the Mantis Tiller easy to roll around your yard, over curbs, and up hills. Attaches to your Tiller in a few minutes. Wheels adjust to any of six different heights. Can be adjusted or removed in seconds.

Helps you keep your shrubs, trees and hedges shaped just the way you like them. Plus, regular trimming promotes new, healthy growth.

For 2-Cycle Tiller only.

Helps you keep your shrubs, trees and hedges shaped just the way you like them. Plus, regular trimming promotes new, healthy growth.

For 2-Cycle Tiller only.

Contains 6 bottles of pre-measured 2-cycle engine oil (2.6 oz each), 1 spark plug, 2 air filter pads, 2 oz. tube of transmission grease, 1 transmission gasket, 2 tine retaining pins, combo wrench, fuel tank funnel. Everything you need "just in case".

Handy accessory for the Mantis Tiller. Straps conveniently to the back of the Mantis Tiller handles. Holds garden debris until you can toss it away. Or, use it to carry your portable phone, hand-held clippers, a combo wrench or your water bottle! Made of durable red plastic mesh.

Just like a bicycle kickstand, our Tiller Kickstand lets you park your Mantis Tiller anywhere! Helps stabilize the tiller while you start up the engine, or fill the gas tank. Flips up when tiller is in use; then down to allow your tiller to stand alone. Attaches easily to the base of the tiller handles, and flips up or down for instant use. Durable solid steel construction. Should last as long as your tiller.

The Tine Detangler easily removes weeds and vines that sometimes wrap around the tiller tines and axle. Made of tough steel that will not break, is 10 3/4" long, and has a comfortable plastic coated handle.

Now you can easily, securely hang your Mantis Tiller on the garage or shed wall, out of the way…when it's not in use. Seven pegboard-type hooks (long and short, single and double) let you hang tiller attachments from the rack, too, so they're always where you need them. Screw rack into wall at centerline of studs 16" apart; or bolt a wooden mounting board (not included) to wall and screw rack to it. All hardware is included.